WIDESIGN exam 300-360 Designing Cisco Wireless Enterprise Networks

WIDESIGN exam 300-360 Designing Cisco Wireless Enterprise Networks is a 90-minute, 60-70 question assessment that is associated with the CCNP Wireless certification. This exam tests a candidate’s knowledge of identifying customer and application requirements, applying predictive wireless design principles and conducting site surveys needed to design and optimize Enterprise wireless networks.

View free WIDESIGN 300-360 real exam questions and answers you will meet in your 300-360 exam test. Certpark could give you a good hand to prepare for your 300-360 exam test easily.

Which two types of information must be included in the installation inventory portion of the
post-installation report? (Choose two.)
A. all AP, controller, and MSE administrator credentials
B. the names, locations, IP addresses, MAC addresses, etc. for every AP, controller, and MSE in the
WLAN
C. a layout of the rack that the equipment is installed
D. results of the coverage audit performed with the site survey mapping tool
E. the number and type of all WLAN clients and tags
Answer: AB

Which three options are benefits of U-APSD? (Choose three.)
A. optimized power-save mode periods
B. increased call capacity
C. bandwidth reservation
D. synchronization of the transmission and reception of voice frames
E. efficient roaming
F. priority bandwidth and polling
Answer: ABD

A customer wants to implement a wireless network in a historic location, but is concerned about the
structural and aesthetic impact to the facility.
Which benefit of using wireless mesh addresses these concerns?
A. Power is required only at the installation location.
B. The APs do not have LED lights.
C. More wireless channels can be supported.
D. APs do not need network connections.
Answer: D

An engineer is preparing for an indoor wireless LAN survey and is provisioning a survey kit.
Which three pieces of equipment should be included? (Choose three.)
A. external connector access point
B. integrated antenna access point
C. coax low-loss cable
D. battery operated power supply
E. range finder
F. Yagi antennas
Answer: BDE

300-360 WIDESIGN exam tests a candidate’s knowledge of identifying customer and application requirements, applying predictive wireless design principles and conducting site surveys needed to design and optimize Enterprise wireless networks.

Your email address will not be published. Required fields are marked *